Share and access USB controller over the network:

ROV Accessories
1

Hi, I need to be able to share the delta controller over the network to a ground control station for troubleshooting our test ROV.

I have used a number of applications that can do this using virtual passthrough mode or true virtual devise mode. All the solutions have limited success with the Delta controller specifically, causing either BSOD or unrecognisable USB device plugged in.

I know the issue is specifically with the delta controller as I can do passthrough with any other device plugged in.

The USB Composite Device drive it is using in windows is 10.0.22621.5124 - 21/06/2006. Is there a newer or specific driver I can use to test to see if it resolves the issue.

Thanks again for your assistance.

2

Hello,

I believe we used Virtualhere before but its been a very long time.

Our HCU uses Window’s generic HMI (Human Machine Interface) there are no other drivers. We have do it this way to facilitate a serial connection to allow programming of the HCU through the same USB port.

Cheers,
E.

3

Hi DeltaROV

Thanks for the response, I have tested with Virtual Here and while it works for all the other HID devices, it does not work with the controller. Do you provide an HID-to-XInput Wrapper driver for the controller perhaps?

Thanks again.

4

Hello,

Sorry we do not.

We will run tests on our side to check this.

Regards,
Etienne